Hogtunes NCA 450-RM : 4 Channel Amplifier / 4x50 watts (201 User Manual download pdf (Page 4)

INSTALLATION INSTRUCTIONS

Step #1: Remove the seat and both wires (+ and -) from the battery.

Step #2: Remove your outer fairing/headlamp assembly and set aside. Refer to

a service manual if you need help with this. NOTE: Placing a towel or

something similar on the front fender can help prevent “dings” or

scratches from dropped tools or fasteners. Expletives will also be kept

to a minimum!

Step #3: Over top of the radio,

pull up to release each

wire harness from the

black plate via the

factory “Christmas

Tree” fasteners. If your

bike has a factory

GPS, the small square

antenna will need to

be relocated just

behind the voltmeter

as shown in Fig 1.1.

Remove the four

factory T-20 “Torx”

screws that go through

the top of the black plate

and into the top of the radio.

Set these screws aside for now.

Step #4: The ampliﬁer comes pre-mounted to a silver mounting plate. Locate and

remove the four screws (2 per side) that attach the amp to the silver plate.

Put these screws just removed and the ampliﬁer aside for now.

Figure 1.1 - The white circle shows the new location

for GPS Antenna if your bike came factory equipped

with this feature.

1 2 3 4 5 6 7 8 9 10 11 12

No comments

Hogtunes NCA 450-RM : 4 Channel Amplifier / 4x50 watts (201 User Manual Page 4